Thingiverse
Ender 3 automatic shutdown
door BoB_1989
8
Downloads
10
Likes
1
Makes
I was thinking that it would be great if the printer could turn itself off when it was done printing.
This "thing" does just that.
It is used to attach the original switch to the z axis.
A G-code is then entered in the slicer, which sets the Z axis to +500 after the print is done
The Z-axis moves up after the work and switches the printer off.
ATTENTION !!! DANGER TO LIFE !!!
before you change anything on the circuit, ALWAYS pull the plug !
you are responsible for any injuries or damage to your person !
As you can see on the pictures I tried to isolate as good as possible. THERE IS 230V ON THE WIRES !!!
This "thing" does just that.
It is used to attach the original switch to the z axis.
A G-code is then entered in the slicer, which sets the Z axis to +500 after the print is done
The Z-axis moves up after the work and switches the printer off.
ATTENTION !!! DANGER TO LIFE !!!
before you change anything on the circuit, ALWAYS pull the plug !
you are responsible for any injuries or damage to your person !
As you can see on the pictures I tried to isolate as good as possible. THERE IS 230V ON THE WIRES !!!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
