Thingiverse
Ender 3 basic temp tower Polycarbonate
von TronskiFPV
3
Downloads
2
Likes
0
Makes
Print this in vase mode
***This was more of a learning print than a good temp tower. Speeds in this print are ~15mm/s. At that slow speed >275c will cook off the slow moving filament before it gets out of the nozzle. It will look like it has moisture in it. this tower will show nice quality at 275 and good layer adhesion at >295. The solution was much faster speeds(~50 mm/s) at 300c. The result was good quality and good layer adhesion that you will not see in this temp tower g code.***
305c-275c
This is for pure layer adhesion and flowrate tests. I dont want to sit at 305 longer than I have to and hope 275 is fine with gizmodorks PC (rated 255-300).
temp changes every 20 mm and stacks like below.
275 top 20mm
285 nest 20mm
295 next 20mm
305 bottom 20mm
***This was more of a learning print than a good temp tower. Speeds in this print are ~15mm/s. At that slow speed >275c will cook off the slow moving filament before it gets out of the nozzle. It will look like it has moisture in it. this tower will show nice quality at 275 and good layer adhesion at >295. The solution was much faster speeds(~50 mm/s) at 300c. The result was good quality and good layer adhesion that you will not see in this temp tower g code.***
305c-275c
This is for pure layer adhesion and flowrate tests. I dont want to sit at 305 longer than I have to and hope 275 is fine with gizmodorks PC (rated 255-300).
temp changes every 20 mm and stacks like below.
275 top 20mm
285 nest 20mm
295 next 20mm
305 bottom 20mm
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!