Ender 3 Control Box Height Offset

So recently I purchased a BL Touch Kit from amazon. However, The problem I ran into was that when I connected the adaptor for the BL-Touch into the motherboard, and connected the cables into the adapter, I then couldn't close the Electronics box.

I created this design to directly address that problem, and should work for others with the same issue.

NOTE:

• Offset = 1cm = 10mm
• Cannot Use The Same Factory Screws. (Longer M3 screws are needed)
• Some Fan Covers/Shrouds will not work with this design (some are too tall and will hit the bed wheels or the bed leveling screw)