Thingiverse
Ender 3 light switch mount
di Schtimpy
1.3k
Download
924
Likes
5
Makes
Small & discrete mount for a rocker switch (https://www.jaycar.com.au/spst-ultra-mini-rocker-switch/p/SK0975 6.5mm x 19mm) used to switch LED lights on/off.
Designed to front-mount the switch unobtrusively on the side of the ender 3 control panel so that it is easy to reach and use, but also discretely mounted in a way that it looks like it is supposed to be there (from the factory) and not added on later.
I have designed it so that the wires from the power supply run in the top left hand side T slot of the Ender 3 base, then the wires pass through this bracket via cut-outs and under the front of the control panel to the switch, so that the wires are fully concealed. See photo with the control panel removed.
When printed using black filament, the switch is very discrete, and as can be seen in the photos, difficult to photograph so that it "stands out" and is easy to see!
I have designed this to be able to be used in combination with a PCB cover fitted as shown in the photos (h
Designed to front-mount the switch unobtrusively on the side of the ender 3 control panel so that it is easy to reach and use, but also discretely mounted in a way that it looks like it is supposed to be there (from the factory) and not added on later.
I have designed it so that the wires from the power supply run in the top left hand side T slot of the Ender 3 base, then the wires pass through this bracket via cut-outs and under the front of the control panel to the switch, so that the wires are fully concealed. See photo with the control panel removed.
When printed using black filament, the switch is very discrete, and as can be seen in the photos, difficult to photograph so that it "stands out" and is easy to see!
I have designed this to be able to be used in combination with a PCB cover fitted as shown in the photos (h
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
