Ender 3 pro Control Box

This control box moves the Control Board out from underneath the Ender 3 or Ender 3 pro. I specifically designed this because any time I wanted to work on the controller I had to either tip the machine or rest it of a table and crawl under.

This Model uses original mounting screws for the Creality Control board and can house a MKS genl v1.0 or the SKR 1.3. it proves cooling via a 120mm fan blowing into the box mounted with m3 screws and nuts.

The screen mounts with the screws you take out as well. Little elbow grease into the holes to cut the threads.

It greatly increases the cooling for the board and will work with the current cable lengths of the printer.

For the fan I used a buck converter was required to step down the 24 volt power supply to 12. The fan is wired directly to the hotend cooling fan block on the mainboard so it is always on and not slaved to the part cooling fan.

I suggest printing a 120 mm fan cover for the top of the fan.


Slightly taller