Thingiverse
Ender 3 Pro Electronics Case
von ibuildit88
12
Downloads
11
Likes
0
Makes
This is a larger electronics case that fits a Raspberry Pi, Buck Converter, and SKR 1.3/1.4.
The main body is designed for M3 heat inserts to hold your parts in place and the lids are designed for use with rare earth magnets to hold them in place.
I feel this is a much better design than most that I've seen out there because it actually gives you some room for your wiring. I've always hated how you basically have to stuff the wiring in but that's not the case with this design!
The main body is designed for M3 heat inserts to hold your parts in place and the lids are designed for use with rare earth magnets to hold them in place.
I feel this is a much better design than most that I've seen out there because it actually gives you some room for your wiring. I've always hated how you basically have to stuff the wiring in but that's not the case with this design!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
