Ender 3 V2 Cable Management

OK, this is just my take on the cable management for the E3 V2. My main principle in making things is that it should be as simple as possible to be efficient. Well, maybe this design is not necessarily the simplest, because it involves a lot of rewiring, but I decided to do it this way after reviewing a ton of options out there with different drag chain designs, etc. I had to take the whole casing for the electronics and the power supply apart, drill some holes in the top cover and install some rubber grommets. All cables are original, except the extruder motor cable - I replaced it with a longer one.

I only used ONE drag chain for the Z-axis, putting the X-axis cables through it as well. The cables are not coming from under the printer base (the factory design), but put through the hole drilled in the top cover near the power supply terminals. Then, all the cables going to the extruder (it's a direct drive mod, so no Bowden tube) and the hotend are just fixed to the mounting bracket