Thingiverse
Ender 3 V2 Filament Guide
von RedSoda
3.9k
Downloads
2.2k
Likes
33
Makes
09/12/2020 - Thanks to 3DForce who noticed that the alignment into the feeder is slightly to the left. As such i have made a 2nd bracket that is 3.5mm shorter for those who prefer it shorter.
Filename: E3V2_Bracket_SHORT_-3.5mm.stl
-------------------------------------------
This is an Ender 3 V2 Filament Guide, remixed from kruselandon12 and originally from Holspeed. (Thumbs Up to you guys!)
Redesigned the bracket to line up accurately with the Ender V2's filament feeder.
Wheel and spacer are the originals.
I used 2 spacers and although it works it was slightly too wide in my view.
Holspeed https://www.thingiverse.com/holspeed/designs
kruselandon12 https://www.thingiverse.com/kruselandon12/designs
Filename: E3V2_Bracket_SHORT_-3.5mm.stl
-------------------------------------------
This is an Ender 3 V2 Filament Guide, remixed from kruselandon12 and originally from Holspeed. (Thumbs Up to you guys!)
Redesigned the bracket to line up accurately with the Ender V2's filament feeder.
Wheel and spacer are the originals.
I used 2 spacers and although it works it was slightly too wide in my view.
Holspeed https://www.thingiverse.com/holspeed/designs
kruselandon12 https://www.thingiverse.com/kruselandon12/designs
RedSoda veröffentlicht auch auf
7 zusätzliche Modelle auf 2 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
