Ender 3 V2 LED Light

This is my first published thing, so apologies if there any mistakes.

This is a simple LED strip bar which can slide into your Ender 3 v2's top rail. It covers the rail between the vertical pillars to have maximum possible length. Idea is to stick the LED strip to the bar at the bottom so that you have enough light falling onto the print. The LED strip is to be powered by a portable battery that you can mount the way you like. See the photos how I have mounted it in a way it can be taken off easily for charging. My plan is to setup a camera with Raspberry pie to watch the print on laptop, but didn't have enough light reaching the print to see the printing issues closely.

I printed it with PLA using 0.12 mm layer height, no support, 100% infill as it doesn't take much filament and 4 mm brim. Print two, one on each side.

I did not spend much time thinking about how to better flow the LED strip from one end to other, but current setup is also not that bad.