Ender-5 Electronics Relocation (Yet another)

About the relocation;

I got the idea from https://www.thingiverse.com/thing:3830464. Moving the electronics out of the cube structure gets me one step closer to an enclosed printer.
Also I will soon receive the new 32-bit 4.2.7 ARM-based controller board and with the electronics on the back, access is easier.

Although technically not a make of that thing, I do want to list it here as attribution.


About the remix;

There is not much left of the original file.
- It is basically a 20 mm x 40 mm bracket, originally it was 40x40
- the bracket is now 40 mm wide, originally 20
- the extrusion-groove-guides are rotated 90 degrees
- the thickness of the bracket is reduced 1mm where the bolt-head goes, so I can use M3x8, M4x8 bolts (x10 bolts are slightly too long and scrape the extrusion, instead of gripping the bracket)
- the hole for the electronics case mount is at a specific location, not useful for a regular 20x20 corner ;)

So as far as remixing goes; this is more att