Ender 5 Hotend Cable Guide

I didn't like how the filament tube and the cabling sleeve for the hotend were cabled tied together as the tube is quite short and was making some quite tight angles at the far corner of the print bed.

After cutting all but the last cable tie however the cable sleeve was in danger of getting caught behind the stepper. I printed up this attachment which bolts to the frame just past the stepper and cable tied the sleeving on top of it, with enough slack to allow the hotend to move to the far X coordinate.

The bolt holes could be countersunk more to accomodate the bolt heads, but it hasn't caused an issue with mine, so I've been lazy.