Ender 5 Plus E3D Hemera Adapter

Ender 5 Plus Hemera Mount and X-Axis Micro-Switch Extension.

I used Dan Rock's Ender 3 Mount and modified it to fit the Ender 5 Plus, additionally I used his Cooling Fan Duct design without modifications for the stock cooling fan. The X-Axis Extension is required and uses existing hardware to mount.

Dan's tutorial and parts can be found here:
https://e3d-online.dozuki.com/Guide/Hemera+Creality+Ender+3+(CR-10)+Upgrade./107?lang=en

For my Hemera conversion, I used the stock Ender 5 Plus Thermistor, Heater, and Fans and purchased a longer length stepper motor cable.

I used Octoprint's EEPROM to modify E-Steps and PID Tune the stock Thermistor.

Parts Required:
1.5m or longer (preferred) Stepper Motor Cable
3 M3x8 Screws (Mount Hemera to Adapter)
2 M3x8 + 2 M3 Nuts (Mount BL Touch)
Refer to Dan Rocks' Ender 3 E3D Guide for hardware to mount fans.

I printed these in PETG at 100% infil for strength. PLA and lower infil will probably work just fine but I have not tested