Ender 5 Raspberry Pi 4 | 3 Electronics Box

This is a little box I threw together to house my Raspberry Pi 4 in the frame of my Ender 5. It can hold a few relays or buck converters and has an internal wire strain relief for the power plug (just zip tie the cable to the support).

It's big enough to house a Raspberry Pi with a fan hat (40mm internal height, minus standoffs for Raspberry Pi). I couldn't find a case that would accomidate the hat linked below so, I made my own. It has a port that can be capped for the Pi cam cable and large holes in the bottom to allow for wires to exit as well as two additional cut outs for holes in the top and vents. There is also a removable panel in the back for access to the Raspberry Pi's SD card.

***Note: This will not work with the electronics box in the stock location (bottom). You'll need to relocate it because of the Power Supply Cable as noted by jsjamboree.***

I printed this without supports except for the channel on the frame. This will all print on a stock Ender 5. You don't