Thingiverse
Ender 6 Extruder Relocation Bracket
por prozente
66
Descargas
22
Likes
0
Makes
This is a mounting bracket I created to relocate the extruder on the Ender 6 from the side to the top.
I used two M3 T slot nuts to move the wiring harness more to the right. Then I used two M4 nuts, four M4x20 screws and two M4 T slot nuts. You will have to put the M4 T slot nuts in the slot prior to attaching them to the screw.
I swapped the cables for the extruder and the Y motor, since the Y motor cable was just a little longer.
I used two M3 T slot nuts to move the wiring harness more to the right. Then I used two M4 nuts, four M4x20 screws and two M4 T slot nuts. You will have to put the M4 T slot nuts in the slot prior to attaching them to the screw.
I swapped the cables for the extruder and the Y motor, since the Y motor cable was just a little longer.
prozente también publica en
7 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
