Thingiverse
Ender3 plotter cutting head mount
door adam_adam_adam_adam
1
Downloads
4
Likes
0
Makes
This is a cutting head mount for modding your ender 3 to be a plotter. It fits any generigc rotating head cutter with a diameter of 11.5 mm.
I recommend printing the parts in the orientation as shown in the image with supports enabled. If you find a better way let me know!
As this is a very snug fit, you will most likely have to do some edge chamfering after printing, before being able to pop in the cutting head.
The holder is designed to mount directly on top (or in place) of a CR touch module. To secure the cap to the holder you can use a zip tie.
Amazon link for the cutting head I used:
https://www.amazon.de/dp/B0BVVV1KB5
I recommend printing the parts in the orientation as shown in the image with supports enabled. If you find a better way let me know!
As this is a very snug fit, you will most likely have to do some edge chamfering after printing, before being able to pop in the cutting head.
The holder is designed to mount directly on top (or in place) of a CR touch module. To secure the cap to the holder you can use a zip tie.
Amazon link for the cutting head I used:
https://www.amazon.de/dp/B0BVVV1KB5
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!