Endless filament shelf

This is 3D printable endless shelf system for storing a lot of filament under your ceiling. You need to print4x wall mountpair´s of Ceiling mount - amount depends how long storage you want ( I recommend adding a ceiling mount´s every 8 spools of 1kg filament )Circle lock´s - if you want use only wall mount´s (your storage shelf will be short), you will need to print only 4 lock´s. If you want longer storage, you will need to print 4 more lock´s for every ceiling pair.An ordinary broom handle with a diameter of up to 24 mm can be used as a support bar. I recommend an axial distance of the rods of about 15mm Assembly instructionScrew the wall mount to the wall at a distance of 23.5 mm from the ceiling to the centre of the circle.Screw the ceiling mount to the ceilingCut a sufficient number of support rods of a length equal to the distance between the wall bracket and the ceiling bracket.Slide the round locks onto the bar, with the larger bevel towards the ends. Insert the bar with the lo