Thingiverse
Engineering WORKBENCH - Drill Press , Table Saw , Tools
di jlsilicon
507
Download
393
Likes
0
Makes
I have seen an assortment of Tool Assemblies across the thgivrs and internet. So I decided to put all of the Tools together into one Large WorkBench. This is a WorkBench incorporating a DrillPress and a CircularSaw, and Multiple Expansion arms for additional Tools. The WorkBench sizes to about 18-inches by 10-inches by 12-inches.
* Drill-Press (on leftside)
* Circular-Saw / Router (on rightside)
* Work Table (in center)
All Tools have:
* Rear X-Adjustment via Rear Main Horizontal Rods,
* Z-Vertical Rear Rod Adjustment,
* X/Y Positoning Arms.
All the Tools are easily removed and Re-mounted on the Rear-Rods.
All Wing-Screws are used to allow the User / Engineer to raise/lower the Tools on the Rear Vertical Rods. There are Wing-Screws that allow the Arms to loosen to adjust X/Y-Distance. Also Adjustments for Tool-Tilt.
This can be done starting from the Frame , then adding Modular Pieces: Rear-Vertical-Rods with Arm and Tool-Mount.
The Bottom Frame as picture
* Drill-Press (on leftside)
* Circular-Saw / Router (on rightside)
* Work Table (in center)
All Tools have:
* Rear X-Adjustment via Rear Main Horizontal Rods,
* Z-Vertical Rear Rod Adjustment,
* X/Y Positoning Arms.
All the Tools are easily removed and Re-mounted on the Rear-Rods.
All Wing-Screws are used to allow the User / Engineer to raise/lower the Tools on the Rear Vertical Rods. There are Wing-Screws that allow the Arms to loosen to adjust X/Y-Distance. Also Adjustments for Tool-Tilt.
This can be done starting from the Frame , then adding Modular Pieces: Rear-Vertical-Rods with Arm and Tool-Mount.
The Bottom Frame as picture
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
