Thingiverse
ESC Protector
von HyphPV
237
Downloads
172
Likes
3
Makes
**Untested for fit until this text is removed.**
My take on an ESC protector. This is designed to fit over a Racerbee 30A ESC and should comfortably fit anything smaller. Small slots to let some air in and zip tie channels to keep it in place. Clam-shell design keeps your ESC safely off the carbon fiber without need for heat shrink or electrical tape. Print vertically, no supports.
My take on an ESC protector. This is designed to fit over a Racerbee 30A ESC and should comfortably fit anything smaller. Small slots to let some air in and zip tie channels to keep it in place. Clam-shell design keeps your ESC safely off the carbon fiber without need for heat shrink or electrical tape. Print vertically, no supports.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!