Thingiverse
esp32-case extended version
von kotl
5
Downloads
5
Likes
0
Makes
- Longer version than original to fit newer variants
- Includes holes for additional pins
- Holes no longer go through entire model
- Holes are slightly bigger to avoid fusing material from the sides on printers with lower quality
- Mounting holes
- No pins required, you can just use a small screwdriver if needed
- Top part has additional margins (+0.2/+0.4mm to have a gap to fit).
- Includes holes for additional pins
- Holes no longer go through entire model
- Holes are slightly bigger to avoid fusing material from the sides on printers with lower quality
- Mounting holes
- No pins required, you can just use a small screwdriver if needed
- Top part has additional margins (+0.2/+0.4mm to have a gap to fit).
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
