Eth2GC Case

This is a housing for Webhdx mod for Gamecubes called Eth2gc.

this housing is used for a sd2sp2 pro connector (the sd card reader half is not needed)
a ENC28J60. The size of the model is 56x34mm
there is further information on how to assemble this item on webhdx's discord (https://discord.gg/3gYV7ugW)
Parts needed:
1 - ENC28J60 Ethernet module
1- sd2sp2 pro connector (just the part that plugs into serial port 2)
4 -m3 x 6mm screws are needed to mount the ethernet module
4 -m3 x 10mm screws are need to secure the housing
14 - female dupoint pin connectors
2mm' 2:1 heat shrink

for the rear facing i use 13mm wire or 5 1/4 inches. for the font facing almost half the length is needed

Hot glue for cable management

As for wiring it is: he

Gnd to gnd
3.3v to VCC
CLK to SCK
INT to INT
S0 to D1
S1 to D0
CS to CS

*on the front facing housing there is an half circle cut out for the wires. At this time one needs to cut out the strip left at the diameter of the h