Slicer Discord
Ethernet Dummy Plug – 3D-Druckmodell von Thingiverse Thingiverse

Ethernet Dummy Plug

von juewei
1 Downloads
1 Likes
0 Makes
Zum Modell
This is a simple plug that covers the ethernet socket of my Lenovo P14s laptop.

Ethernet plugs and USB plugs are both ca. 12mm wide. I recently bought a new USB headset, and found that the USB plug on the right hand side of my computer is very handy for connecting the headset. Except for one morning, where I had an important conference and was not paying too much attention while plugging it in -- the headset just did not work.

Later I found, I had plugged it into the ethernet socket, that is right next to the USB socket.

Normally, ethernet sockets are a bit to narrow for USB plugs. E.g. on my other Lenovo laptop, this accident won't happen. But on the P14s, well, Lenovo decided to make the ethernet socket just wide enough so that a USB plug would fit. Not sure why they did this...

Anyway, this little plug solves the issue for me.
Printed with TPU, it snugly fits into the ethernet socket, and prevents accidentially plugging in anything there. My wifi is normally fine, so I rarely
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
TPU
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen