EV100 PRO58 Module Mount

# EV100 PRO58 Mount
This is my design to mount the PRO58 receiver on the Eachine EV100 goggles.
I printed some of the available designs, but I did not like them, so I ended up designing one myself.

The only non-3D printable components are:
* M3 Screw. 10mm long approx.
* M3 Nut
* Nut from an SMA pigtail. I think is 8mm??

## Mounting process
First, screw on the 'locking mechanism' to fix the module to the case.
Once the module is secure just connect the three wires, positive-ground-signal, and fit the EV100 SMA through the 3D printed part. To fix the case to the goggles use the pigtail nut or any sort of nut with the same thread.

The printing settings are below and there is no need for supports.
I hope you find it useful and if you ended up using it, please share a photo. I would love to see it!

Happy printing!