Thingiverse
Exit Window Latch
von dsmith1960
16
Downloads
10
Likes
0
Makes
This is the Latch for the Exit / Egress Window on a Rockwood Mini Lite travel trailer. With age, and an accidential bumping, the original latch broke.
You will need to drill out the existing rivet with a 0.201" drill.
NOTE: This model is in metric units (mm). Scale accordingly for your application.
Update: 07-April-2022: The units on my initial model were set incorrectly. If you downloaded that version you will need to scale it down by 25.4. (Overall values are 69.4 x 19.3 x 6.8)
V2 has been updated to the correct units and (after printing one for my use) the width of the opening for the metal bar has been reduced to remove excess side-to-side movement.
You will need to drill out the existing rivet with a 0.201" drill.
NOTE: This model is in metric units (mm). Scale accordingly for your application.
Update: 07-April-2022: The units on my initial model were set incorrectly. If you downloaded that version you will need to scale it down by 25.4. (Overall values are 69.4 x 19.3 x 6.8)
V2 has been updated to the correct units and (after printing one for my use) the width of the opening for the metal bar has been reduced to remove excess side-to-side movement.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
