Thingiverse
Exploding Kitten Dragon Shield Box
von sfk
5
Downloads
3
Likes
0
Makes
This card holder holds two 30 mm stacks of cards 68 mm by 94 mm.
The holder itself is 31mm heigh, 150 mm wide and 101 mm long.
It's made to fit in an Exploding Kittens box and hold sleeved cards.
Dragon Shield sleeves were measured for this build though many other sleeves should fit the 68 mm by 94 mm profile which give about 1.5 mm room.
The Thingiverse configurator might not work, so download openSCAD, an opensource math cad that will allow you to customize the parameters and render a customized model.
The holder itself is 31mm heigh, 150 mm wide and 101 mm long.
It's made to fit in an Exploding Kittens box and hold sleeved cards.
Dragon Shield sleeves were measured for this build though many other sleeves should fit the 68 mm by 94 mm profile which give about 1.5 mm room.
The Thingiverse configurator might not work, so download openSCAD, an opensource math cad that will allow you to customize the parameters and render a customized model.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
