Slicer Discord
Extended Golf Handle - Quest 2 – Modelo 3D imprimible de Thingiverse Thingiverse

Extended Golf Handle - Quest 2

por Eagle5432
71 Descargas
50 Likes
3 Makes
Ver Modelo
For putting / golf games on Quest2

Because this uses the original controller orientation it seems to work fine without needing pre calibration for specific grip models, which is as of today is not supported in the games I use. Gripping lower on handle may have unintended results in some games, otherwise if keeping the main hand near original controller grip position this should work per normal, but with the benefit of having somewhere to grip for your second hand.

Be sure to use the wrist strap looped through the hole and attached to your wrist per usual when playing for a more secure setup. The clip alone (even the tighter T2 version) is insufficient IMO but looping a ponytail band or otherwise through that area (or through the wrist strap again) to the controller halo is an additional connection point if desired (see photo under “makes”). The t2 tightening clip should slightly tighten when pushed; may need to be tapped against a hard surface in opposite direction to remove,
Fuente
Thingiverse
Lo que necesitas para imprimir: Principiante Baja confianza
Pieza única
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 0/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
PLA
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección