Thingiverse
Extended touchscreen upgrade stand Ender 3 Pro
by Robbe112
2
Downloads
0
Likes
0
Makes
This is an upgrade from the 'Simple touchscreen upgrade stand Ender 3 Pro'.
With the extension it is possible to change the inclination of the touchscreen for better visibility.
The stand itself has an extra hole to be able to tighten the extension.
Because now the bold on top, which holds also the touchscreen, is too short, you have to put it on the other side (side with one hole). This bold must be replaced by a suitable bolt and nut at least 6mm long.
With the extension it is possible to change the inclination of the touchscreen for better visibility.
The stand itself has an extra hole to be able to tighten the extension.
Because now the bold on top, which holds also the touchscreen, is too short, you have to put it on the other side (side with one hole). This bold must be replaced by a suitable bolt and nut at least 6mm long.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
