Extended Vent Insert

I recently had to print another one of these vent covers however I ran into the issue that the mounting piece was not long enough, so I went ahead and created a longer version of the original model. This version also has a thicker insert to help prevent it from snapping or peeling. Just like the previous model, this gets mounted to the wall using wall anchors and the cover plate just pops on over top of it. If you decided to print this, USE A FILAMENT WITH HIGH HEAT RESISTANCE such as ASA or ABS! Filaments with lower printing temperatures are a lot more prone to warping from the heat coming out of the duct. Here is the link to the original model with the cover plate:https://makerworld.com/en/models/376227#profileId-287654