Thingiverse
EZABL Sensor Placement Assistant
por DanTexasMan
82
Descargas
36
Likes
1
Makes
I use this to properly place my EZABL sensor at the correct height.
I bring the nozzle down to the low end of the part, then the sensor flat on the high part.
The difference in the low part vs the high part is 2mm. That is the recommended height for the sensor to be above the nozzle.
I bring the nozzle down to the low end of the part, then the sensor flat on the high part.
The difference in the low part vs the high part is 2mm. That is the recommended height for the sensor to be above the nozzle.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
