Thingiverse
Face shield, optimized
von deskripta
21
Downloads
21
Likes
0
Makes
Optimized headband and bottom reinforcement for face shield.
The foil pattern is according to Prusa Desing for rc1, rc2 and rc3.
Material is PLA
The headband prints for an hour, the bottom reinforcement for 25 minutes.
Bottom reinforcement is made for foils of thickness of 0.5-0.8mm, strong enough to hold bent foil.
The foil pattern is according to Prusa Desing for rc1, rc2 and rc3.
Material is PLA
The headband prints for an hour, the bottom reinforcement for 25 minutes.
Bottom reinforcement is made for foils of thickness of 0.5-0.8mm, strong enough to hold bent foil.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
