Thingiverse
Face Shield
por 3D-Designs
17
Descargas
19
Likes
0
Makes
Face Shield
Very little parts are required for the finished part.
Parts used:
A4 PPC Film Clear 100-Micron or Binding Comb Covers 250-Micron
Paper Hole Punch.
Hole centres.
80mm between the corner fixings to the centre
and 60mm between the 2 centre fixings
The fixings have a small slot for the Film to sit in, and two side lugs to keep them in place.
This is a modification on parts already being printed for the COVID-19 outbreak.
Very little parts are required for the finished part.
Parts used:
A4 PPC Film Clear 100-Micron or Binding Comb Covers 250-Micron
Paper Hole Punch.
Hole centres.
80mm between the corner fixings to the centre
and 60mm between the 2 centre fixings
The fixings have a small slot for the Film to sit in, and two side lugs to keep them in place.
This is a modification on parts already being printed for the COVID-19 outbreak.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
