Thingiverse
Fadecandy case
door Siti
29
Downloads
16
Likes
3
Makes
A case designed for the Fadecandy LED controller. This suits board fc64x8 Rev B, with 0.1" headers soldered, as sold by Adafruit.
This case has a slide in lid which requires no screws. There are two files for the base, one with tabs to suit M3 screws and one without.
When printed in white ABS, the LED is still visible through the case.
Product link (as of 22/12/14):
http://www.adafruit.com/product/1689
UPDATE 28/12/14: Reduced width of lid after issues with it being too wide to fit into the base (thanks donwulff). Revised lid file to Rev 1.1.
This case has a slide in lid which requires no screws. There are two files for the base, one with tabs to suit M3 screws and one without.
When printed in white ABS, the LED is still visible through the case.
Product link (as of 22/12/14):
http://www.adafruit.com/product/1689
UPDATE 28/12/14: Reduced width of lid after issues with it being too wide to fit into the base (thanks donwulff). Revised lid file to Rev 1.1.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
