Fake EOTech functional

Put slots @45 degrees for lens and a mirror. the long flat piece with the hole in it is for the led as well as the lens....It is a template to trace to get the right fit, but it will need trimming first. I used a DVD split into layers for the plastic because it has a rainbow shine, is slightly tinted, and is easy to cut with scissors. I used the same plastic for the hologram.....You will have to play with the hologram for the right placement. the hole is for a 5mm LED which is supposed to point directly to the front/ middle of the scope which is then reflected off of a mirror finish up into the hologram. I could not get the mirror plate in there, so i just went with it as is. If you do that, the hologram will show much better if u point the led up at it, which is why my pic is so messy, I had to cut the hole open to put the LED in and I just glued thatblue plastic to keep the LED where it is and keep the positive and negative from touching. Oh and just cut the LED/Lens plastic when you