Thingiverse
Learning
Zum Modell
Fall Design Catapult
23
Downloads
23
Likes
0
Makes
This catapult was built using 1/4 inch MDF for the Lakehead Fall Design Competition.
It was cut using an Epilog Mini 24, 40 watt laser.
The bucket of the catapult was 3D printed out of PLA using a Dremel 3D20.
It was cut using an Epilog Mini 24, 40 watt laser.
The bucket of the catapult was 3D printed out of PLA using a Dremel 3D20.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
