Thingiverse
Famicom Disk System Jig
von derGreen
0
Downloads
1
Likes
0
Makes
This is the jig you need to calibrate the Quick Drive head in the Famicom DISK SYSTEM.
It is not quite as accurate as a metal version, but it has the same dimensions and should work.
If you need a quick solution, this will suffice.
A layer height of 0.2 is recommended.
It is not quite as accurate as a metal version, but it has the same dimensions and should work.
If you need a quick solution, this will suffice.
A layer height of 0.2 is recommended.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
