Thingiverse
Fan Grating
von WeeksB
38
Downloads
13
Likes
1
Makes
A grate to help keep you from sticking your 2.5mm wrench into your fan blades.
Designed for the Flashforge Creator fan but should work for other extruder fans.
For Flashforge Creators:
The given screws that hold the extruder components are too short as they only grab ~2mm of threading. This piece + M3x40mm screws should prevent you from stripping out the threading in your extruder motors while simultaneously keeping you from accidentally sticking your wrench into the fan blades.
Designed for the Flashforge Creator fan but should work for other extruder fans.
For Flashforge Creators:
The given screws that hold the extruder components are too short as they only grab ~2mm of threading. This piece + M3x40mm screws should prevent you from stripping out the threading in your extruder motors while simultaneously keeping you from accidentally sticking your wrench into the fan blades.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
