Thingiverse
Faucet Handle
von onurzaim
1
Downloads
5
Likes
0
Makes
Center hole is for 5mm square grip.
This is faucet handle for griping of 5mm square tap. I made this becasue of 5mm square turning tap was detroying the ones I buy from hardware store. Either with PLA or Petg its much better now. I dont have any water leakage anymore. I bundled gasket for using with a TPU filament.
This is faucet handle for griping of 5mm square tap. I made this becasue of 5mm square turning tap was detroying the ones I buy from hardware store. Either with PLA or Petg its much better now. I dont have any water leakage anymore. I bundled gasket for using with a TPU filament.
onurzaim veröffentlicht auch auf
9 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
