Thingiverse
FaucetFalls
von Labadorium
4
Downloads
8
Likes
0
Makes
This should be a tight fit to 24mm faucet-outlets.
Since my one and only printer is set up for fine prints atm and not for speed,
i did not testprint this one YET.
If someone is eager to try, according to the slicer (ideamaker) it should take ~22g.
(.2 nozzle, .1 layerheight, 10% infill, 6 shells, 6 bottom, 8 top = ~12h print)
^----these are my actual settings, would be a waste of time for this very unfine object...
Since my one and only printer is set up for fine prints atm and not for speed,
i did not testprint this one YET.
If someone is eager to try, according to the slicer (ideamaker) it should take ~22g.
(.2 nozzle, .1 layerheight, 10% infill, 6 shells, 6 bottom, 8 top = ~12h print)
^----these are my actual settings, would be a waste of time for this very unfine object...
Labadorium veröffentlicht auch auf
3 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
