Thingiverse
Faust Spinne
von Delta_Makes
66
Downloads
53
Likes
0
Makes
!!DISCLAIMER!!
Panzerfaust in the picture is not included, but for display purposes only! I assume most of you probably have a few of them lying around from your 28mm wargaming, that I did not see the point in making one. If you want to print one, then the panzerfaust in the picture did come from Thingiverse.
This is a 28mm scale Tank Hunter System designed to replace the turret on the Spinne Warlord Games walker, intended for use with the Konflikt 47 game system, but you be you.
I've labeled it as a WIP because I haven't done any final test prints yet. I'll remove the WIP status when I do and find everything to be satisfactory.
Print with supports (should be easy to remove, I made sure of that), otherwise, I'm unsure if any particular print settings are required, I print at .1 layer height and it works just fine.
Lore-wise, for those who care, this is a more desperate solution, used by partizans, cultists, or volkstrom.
This design isn't just influenced by Clockwork Go
Panzerfaust in the picture is not included, but for display purposes only! I assume most of you probably have a few of them lying around from your 28mm wargaming, that I did not see the point in making one. If you want to print one, then the panzerfaust in the picture did come from Thingiverse.
This is a 28mm scale Tank Hunter System designed to replace the turret on the Spinne Warlord Games walker, intended for use with the Konflikt 47 game system, but you be you.
I've labeled it as a WIP because I haven't done any final test prints yet. I'll remove the WIP status when I do and find everything to be satisfactory.
Print with supports (should be easy to remove, I made sure of that), otherwise, I'm unsure if any particular print settings are required, I print at .1 layer height and it works just fine.
Lore-wise, for those who care, this is a more desperate solution, used by partizans, cultists, or volkstrom.
This design isn't just influenced by Clockwork Go
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
