Thingiverse
Feather Tiny box
von torabaito
2
Downloads
3
Likes
0
Makes
This is a very small box for the Adafruit Feather micro controllers. if you dont need space for a lot of electronics, this might be all you need.
Hardware:
- M3 Flat head
- M2.6x5 button
For mounting, There are 2 M3 countersunk holes in the bottom, I used these to mount slider blocks but could be used to screw it to any number of things.
To bolt on the top, i used some M2.6x5 screws that i had from RC, partially because i had them, partially because they were adorable as all frig. i think a slightly more "standard" M2.5 would also fit. Not that that is a easy standard either.
One thing i never went back to adjust that could be fine tuned is the clips on the side of the bottom to secure the board in without screws.
Hardware:
- M3 Flat head
- M2.6x5 button
For mounting, There are 2 M3 countersunk holes in the bottom, I used these to mount slider blocks but could be used to screw it to any number of things.
To bolt on the top, i used some M2.6x5 screws that i had from RC, partially because i had them, partially because they were adorable as all frig. i think a slightly more "standard" M2.5 would also fit. Not that that is a easy standard either.
One thing i never went back to adjust that could be fine tuned is the clips on the side of the bottom to secure the board in without screws.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
