Thingiverse
Fence post cap
von rakoivun
10
Downloads
6
Likes
0
Makes
Fence post cap. Could not find right size close by where I live. Material cost about 0.3€ / pop (9€/kg spool price).
Print in 2 parts. Glue together. Idea is to save in support material.
One bottom+cap takes some 2.5h to print.
Material white PLA.
0.35 mm layer.
Attach with nails to the pole.
In one of the pictures you can see nasty layering. That was the time when I printer the top part flat. Since then I moved printing them on their side (which looks wrong but it works nicely) and print quality was really good.
Idea is to paint over them later on which will smooth out rough edges.
Print in 2 parts. Glue together. Idea is to save in support material.
One bottom+cap takes some 2.5h to print.
Material white PLA.
0.35 mm layer.
Attach with nails to the pole.
In one of the pictures you can see nasty layering. That was the time when I printer the top part flat. Since then I moved printing them on their side (which looks wrong but it works nicely) and print quality was really good.
Idea is to paint over them later on which will smooth out rough edges.
rakoivun veröffentlicht auch auf
48 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
