Thingiverse
Fender Jazzmaster Pickup Riser
door CakeMadeOfSausage
1
Downloads
2
Likes
0
Makes
A couple of **Fender/Squier Jazzmaster pickup risers** in different heights.
Because of the construction of Jazzmaster pickup, chances are you run out of pickup height. This is where the pickup riser i designed comes in.
- First, loosen the pickup screws until the pickup reaches its maximum height.
- Then, measure the distance between the highest pole piece to strings with a caliper or ruler.
- Subtract the ideal pickup distance from strings (around 2 to 2.5mm, but look it up or adjust to taste).
- Pick a STL according to the result of the calculation, and you should have an ideal setup now.
**Have fun!**
Because of the construction of Jazzmaster pickup, chances are you run out of pickup height. This is where the pickup riser i designed comes in.
- First, loosen the pickup screws until the pickup reaches its maximum height.
- Then, measure the distance between the highest pole piece to strings with a caliper or ruler.
- Subtract the ideal pickup distance from strings (around 2 to 2.5mm, but look it up or adjust to taste).
- Pick a STL according to the result of the calculation, and you should have an ideal setup now.
**Have fun!**
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
