Thingiverse
Fenix E05R diffuser
von faltypi
1
Downloads
0
Likes
0
Makes
Light diffuser for Fenix E05R, designed in Tinkercad. Enjoy!
The diameter of the flashlight is 15mm, but from my experiments I found that best size for the cap is when it's 16mm and has 16 sides (not 12, not 20, not 24, not 32 :D)
I've printed mine using white PLA at 0.12 layer height. Border width doesn't seem to make difference, as most of light goes through holes.
The diameter of the flashlight is 15mm, but from my experiments I found that best size for the cap is when it's 16mm and has 16 sides (not 12, not 20, not 24, not 32 :D)
I've printed mine using white PLA at 0.12 layer height. Border width doesn't seem to make difference, as most of light goes through holes.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
