Fidget Lever Cube

First, lay out all of the 3D printed parts in 5 groups with 1 platform, fulcrum, and cap in each group. Put the body on the side. (Image 1)Next, loosely place the first platform in between the two triangles on top. Try to line up the hole on the platform with the holes in the triangles. (Image 2)Third, slide the fulcrum through the triangle holes, going through the platform as well. In order to make sure that it went trough the platform, push the lever up and down and make sure that it is held in place. (Image 3)Finally, add a cap on the end of the fulcrum sticking out. About half of the time, my caps went in perfectly but for the other caps, I had to apply some glue in order for it to stick firmly. (Image 4)Repeat steps 2-3 with the other four sets of parts.