Fidget Slider

It's a fidget slider that has a capture rail to keep it from falling apart. ball bearing make it run smooth and alternating magnet make a snappy soundyou will need:8x 5mm x 2mm magnets4x 2.5mm precision steel balls instructions:1. print the two parts2. insert 6 magnets in the base, alternate between N and S (+ - + - + -) and firmly push so it's flush with the surface3. insert 2 magnets in the cover, alternate between N and S (- +) and firmly push so it's flush with the surface4. insert 1 steel ball per track in the base, a dab of grease in the ball paths will make it run smooth and keep it in place for the next step5. line up the cover to the base, carefully lower it, it should snap into place. if you feel the cover bounce off the base, flip it 180 so the + - line up correctly6. move the cover side to side in the base to “wear in” the two surfaces the magnets should be enough to keep the two halves together update (july 7, 2024) - using 2 balls per track gives less resistan