Thingiverse
Fidget Spinner - 6Washers
von huffray
0
Downloads
0
Likes
0
Makes
Had some washers and a 608 skate bearing and I thought I would do the only reasonable thing... make a fidget spinner!
Stop the print before it prints the top retainers, insert your washers, and then finish the print. They will be held in nicely FOREVER.
Washers I used are about 32 mm (1.25 in) diameter and about 1.5 mm (0.05 in) thick. Use two per slot for a total of 6Washers (the name.. get it?)
Stop the print before it prints the top retainers, insert your washers, and then finish the print. They will be held in nicely FOREVER.
Washers I used are about 32 mm (1.25 in) diameter and about 1.5 mm (0.05 in) thick. Use two per slot for a total of 6Washers (the name.. get it?)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
