Thingiverse
Fidget Spinner
di JakesYaBoi
10
Download
6
Likes
0
Makes
These can be printed in two colours and different types of filament with a single extruder if you print off half and then switch filament. These were made to have a tight fit so the bearings do not fall out. A suggestion would be to use the back of a screwdriver e.x. to bang in the bearings. You also don't even need to put bearings in the outside ones. You could just print off something that is 22mm in diameter.
This was made in fusion 360 and Printed on the Anet A8.
Print Off
2x Half the spinner
2x 1 Cap
This fidget spinner uses 608 bearings (22mm in diameter) or print off fake beaings.
This was made in fusion 360 and Printed on the Anet A8.
Print Off
2x Half the spinner
2x 1 Cap
This fidget spinner uses 608 bearings (22mm in diameter) or print off fake beaings.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
