Thingiverse
Fidget spinner
von salvogi
2
Downloads
2
Likes
0
Makes
This fidget spinner is a function test for a 3D printed bearing.
The bearing in question supports limited loads and has greater friction but is light and cheap.
The gears have a pressure angle of 40 degrees.
A gap of 0.05mm has been left between the cogwheels, this gap is suitable for my type of printer (Zonestar P802N).
The bearing in question supports limited loads and has greater friction but is light and cheap.
The gears have a pressure angle of 40 degrees.
A gap of 0.05mm has been left between the cogwheels, this gap is suitable for my type of printer (Zonestar P802N).
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
