Thingiverse
fidget spinner
von GeoffHackett
1
Downloads
3
Likes
0
Makes
Based on a very classic simple design. Requires four skate board bearings. One for the centre and three for the outside. The bearing should be a tight fit, they are on my printer so good luck with it. 608ZZ for the bearings you can get them on ebay etc.. With a cat head finger protection clip!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
