Thingiverse
Fidget Spinner
door LikeMaker
1
Downloads
3
Likes
0
Makes
Designed up this fidget spinner to use in stressful situations. Just learned to use fusion 360 and wanted to make something in Thingiverse.
Printing:
No supports, no rafts
100% infill is needed to maximize the spinning time.
Bearing is needed.
Letters - Print flat, already scaled to fit nicely in the bearing.
When you have all the parts ready, simply push the bearing into the hole in the spinner part. It might be tight, but once you get it there you won't need anything else to secure it. After that, you need to insert one of the holding parts to the bearing, and if it's not tight you could use some super glue or something to make it be tightly in place. Then insert the other holding part to the other side of the bearing and tighten it into the other part.
Printing:
No supports, no rafts
100% infill is needed to maximize the spinning time.
Bearing is needed.
Letters - Print flat, already scaled to fit nicely in the bearing.
When you have all the parts ready, simply push the bearing into the hole in the spinner part. It might be tight, but once you get it there you won't need anything else to secure it. After that, you need to insert one of the holding parts to the bearing, and if it's not tight you could use some super glue or something to make it be tightly in place. Then insert the other holding part to the other side of the bearing and tighten it into the other part.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
