Thingiverse
Fidget Spoon
por elijahmock
3
Descargas
1
Likes
0
Makes
A Fidget Spoon! Similar to a fidget spinner, but with 'spoons' on the ends. Put a bearing in the middle. (Your bearing may not fit in the middle. This is designed for an about 22 mm bearing diameter. You can scale it up or down if you need to change the size.) Then, put 2 pennies in each of the 3 spoons to use as weight. Spin away! I got a 1-minute spin time with an old bearing, so it spins well!
If you would like a Fidget Spoon already printed with bearings and pennies in it, you can go to http://www.92spoons.com/products/fidget-spoon
Note: The Fidget Spoon and the caps for it print much better upside down because the supports are cleaner and look better when finished, so you should use the upside down file. I recommend using concentric supports.
If you would like a Fidget Spoon already printed with bearings and pennies in it, you can go to http://www.92spoons.com/products/fidget-spoon
Note: The Fidget Spoon and the caps for it print much better upside down because the supports are cleaner and look better when finished, so you should use the upside down file. I recommend using concentric supports.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
